Alarm failure
Over-travel alarm, indicating that the machine has reached the limit position during operation, please check according to the following steps:
Whether the designed graphic size exceeds the processing range.
Check whether the connecting wire between the machine motor shaft and the lead screw is loose, if so, please tighten the screws.
Whether the machine and the computer are properly grounded.
Whether the current coordinate value exceeds the software limit value range.
Alarm and release
When overtravel, all motion axes are automatically set in the jog state, as long as you keep pressing the manual direction key, when the machine leaves the limit position (that is, out of the overtravel point switch), the connected motion state will be restored at any time.
Pay attention to the direction of movement when moving the workbench, and it must be far away from the extreme position.
The soft limit alarm needs to be cleared to XYZ in the coordinate setting
Non-alarm fault
1. The repetitive machining accuracy is not enough, please check according to the second item of the first.
2. The computer is running and the machine is not moving. Check whether the connection between the computer control card and the electrical box is loose. If so, insert it tightly and tighten the fixing screws.
3. When the machine cannot find the signal when returning to the machine origin, check according to Article 2. The proximity switch at the machine origin is malfunctioning.
Output failure
1. No output, please check whether the computer and the control box are well connected.
2. Open the settings of the engraving manager to check whether the space is full, and delete the unused files in the manager.
3. Whether the wiring of the signal wire is loose, carefully check whether the wires are connected.
Engraving failure
1.Whether the screws of each part are loose.
2. Check whether the path you have processed is correct.
3.Whether the file size is too large, causing computer processing errors.
4. Increase or decrease the spindle speed to adapt to different materials (usually 8000-24000)
5. Loosen the chuck of the knife, turn the knife in one direction and clamp it, and put the knife upright, so as to avoid the engraving object is not smooth and clean.
6. Check whether the tool is damaged, replace it with a new one, and re-engrave.
