How to install the cutter of the engraving machine quickly and correctly? If the engraving machine tool is installed correctly, the engraved pattern can be more accurate, and the tool is not easy to break during use. How to install the engraving machine tool quickly and correctly? The following five steps are hoped to be helpful to you all.
1 There are many gaps in the chuck. Before each tool is installed, the chuck needs to be cleaned with gasoline or WD40 cleaning agent, and the residue in the chuck gap should be checked and removed.
2 The fit between the chuck and the shaft is in contact with the taper hole at the end of the shaft. If the contact is not good, the tool will not be easy to install. Make sure that the taper has good contact. The shaft cone must be cleaned with gasoline or WD40 cleaning agent before loading the knife
3 Put the chuck into the pressure cap, turn the clamp spring slightly, wait until the eccentric part of the pressure cap is recessed into the chuck groove, push the chuck evenly in the direction of the arrow, and then it can be put into the pressure cap
4 The chuck and the pressure cap are installed on the machine spindle together, the cylindrical shank of the tool is cleaned and put into the holding hole. After confirming that the chuck and the tool are aligned, screw the pressure cap in place by hand. Then use a wrench to tighten the pressure cap evenly and firmly until the tool is firmly clamped before use
5 When loosening the knife, use the wrench to twist the pressure cap in the opposite direction. If you need to change the chuck, loosen the pressure cap to bring out the chuck and the tool, remove the tool, push the chuck in the direction of the arrow to push it out, and then change it as needed. You can use chucks with other apertures.
